Description:Dedicated to receiving calls between the aircraft and the tower, matching with the good performance antenna (VHF Yagi paragraph), it can receive calls within approximately 190Km(maximum acceptable) between the various types of aircraft and the tower calls

Adopts a band-pass filter, 3355 high-level, NE602 mixer, MC1350 programs in place, can receive 118-136MHz AM signal

Printed directly on the PCB board trace inductance, greatly simplifying the assembly of difficulty

AGC circuit to ensure comfortable listening, while the noise-canceling function avoids the long time noise

12V power supply, the 9

2x7

5cm PCB board can be placed in the 97x40x120mm aluminum chassis directly

Tip: Due to the VHF bands have similar propagation of light---- rectilinear propagation , the receiving location accessible from the airport(distance greater than 25Km's) must be installed VHF Yagi antenna contour segment gain antenna;Make sure you steer clear of obstacles if there are large obstructions(including but not limited to tall buildings, mountains, towers) between the receiving location and the airport

Specification:Material: PlasticSize: Approx

92 x 75 x 10 mm / 3

62 x 2

95 x 0

39 inchPackage Includes:1 Set of Air Band Receiver Aviation Radio DIY Kit1 Piece DC Digital DisplayNote:1

The shipment is all scattered electronic components

The finished board picture displayed by the store is only for reference when purchasing

2

Please allow a slight difference between the size from the above and the actual item due to manual measurement

3

Due to the difference between different monitors,there could be a little color difference acceptable, please kindly note